MACHINING ANGLES
|
MACHINING ANGLES |
|
||||
| Zone : d:\workzones\parkerward\pumpe\ | NC Machine : Heidenhain 426 - Tip of Tool |
| Generated : Dec 01 14:01:17 | Programmer : Chris Parker | Project : spt- |
| Commentairs : |
| Surface File: pumpe.wnc | Offset allowance : 0.000 |
| SET UP DETAILS |
| Path | File | Machining Type | T | Path | Diam | C.rad | 1st Angle | 2nd Angle | Machining View | Cutter description |
| 1 | spt-01.h | High-Feed Roughing | 0 | Bull-nose | 25.00 | 2.00 | 0.00 | 0.00 | c000 | |
| 2 | spt-02.h | Contour Re-Roughing | 0 | Ball | 8.00 | 0.00 | 0.00 | c000 | ||
| 3 | spt-03.h | Z-level finishing | 0 | Ball | 10.00 | 0.00 | 0.00 | view000 | ||
| 4 | spt-04.h | Optimized Z-level finishing | 0 | Ball | 10.00 | 0.00 | 0.00 | c000 | ||
| 5 | spt-05.h | Contour remachining | 0 | Ball | 6.00 | 0.00 | 0.00 | view000 | ||
| 6 | spt-06.h | Z-level finishing | 0 | Ball | 10.00 | 0.00 | 0.00 | view000 | ||
| 7 | spt-07.h | Optimized Z-level finishing | 0 | Ball | 10.00 | 0.00 | 0.00 | c000 | ||
| 8 | spt-08.h | Contour remachining | 0 | Ball | 6.00 | 0.00 | 0.00 | view000 | ||
| 9 | spt-09.h | Contour remachining | 0 | Ball | 4.00 | 0.00 | 0.00 | view000 |